SA340TS Mounting Kit ‘94 Crown Victoria Installation Guide

by autocar

Sponsored Links

Installation:
1. Attach the siren driver to the mounting bracket before installing.
2. Install the mounting bracket and siren driver by pushing through the air flow cut-outs on the vehicle’s underside, and by hanging the bracket by the cross member near its centerline.
3. Locate the siren clamp bracket assembly behind the vehicles cross member
4. Thread the 5/16″ hex bolts from the front into the clamp bracket assembly.
5. Push the Twinsonic horn thru the air flow cut-outs on the vehicle underside. Position the horn over the mouth of the driver and thread on the siren tip.
6. Position the entire assembly vertically and tighten the two hex bolts.

(Read More on Free Ebook at PDF Format)

Download SA340TS Mounting Kit ‘94 Crown Victoria.pdf

Posts Related to SA340TS Mounting Kit ‘94 Crown Victoria Installation Guide

69-8610 INSTALLATION INSTRUCTIONS Toyota 2007 Camry I4-2.4L
1. Turn the ignition OFF and disconnect the vehicle's negative battery cable. 2. Disconnect the mass air sensor electrical connection and release the wiring harness ...
2008+ Mitsubishi Lancer Quick LIFT Installation Guide
Step 1 - Unpack QuickLIFT system and verify contents. Remove all items from the packing tube. You should have the following before beginning: * (2) ...
1994-1998 Chevy S10/GMC Sonoma Hidden Hitch Installation Instructions
Step 1: Remove factory bumper from truck, if so equipped. Step 2: Remove factory bolts which secure exhaust tailpipe bracket, but do not completely remove ...
INSTALLATION INSTRUCTIONS BMW 325i E36 2.5L 24V L6 192bhp 1991-1995
1. Ensuring that the ignition is switched off, disconnect the lead to the negative battery terminal. 2. Unclip & remove the electrical harness plug from ...
BX3716 Installation Instructions 1987-91 Toyota Camry
Installation of this baseplate requires removing the vehicle's tie down brackets. On 1991 models, the lower metal bumper/spoiler will need to be removed. 1. Read ...