Helms Acura Integra Service Manual 1990-1993 PDF

December 30th, 2009 by | Filed under Acura

Hatchback:
1. Remove the screw, then carefully remove the inner handle trim plate.
Note: Take care to scratch the inner handle trim plate
2. If applicable, remove the regulator handle by pulling the clip out with a wire hook.
Note: When replacing the door speaker, remove the speaker cover and mounting screws.
3. Remove the screw and carefully pry up the armrest pocket.
Remove the screw and clips (see trim pad remover) attaching the door panel
Remove the door panel by pulling it upward and disconnect the power window connector and power door lock connector.
Note: Remove the panel with as little bending as possible to avoid creasing or breaking it.
4. Carefully remove the plastic cover
5. Remove the screws and disconnect the lock rod A and inner handle rod, then remove the inner handle.
Note:
When installing make sure the rods are fastened correctly
Take care not to bend lock rod A and inner handle rod
6. Remove the screw, disconnect the lock rod A and B, then remove the lock crank
Note: Take care not to bend lock rod A and B
7. Reconnect the window switch to operate the regulator
8. Raise the glass fully
9. Use protective tape around the edge of the outer handle to prevent stratching the paint.
10. Pull out the retainer clip, then remove the lock cylinder.
11. Remove the mounting bolts. Pull the outer handle out, then pry the outer handle rod out of its joint using a flat tip screwdriver.
Caution: When prying with a flat tip screwdriver, wrap it with protective tape to prevent damage.